Porch flooring – Porch flooring is installed in a similar way to the interior wood floor, with boards that are nailed down and held together at the sides of the tongue and groove fittings. However, porch decking is much longer, so you can put a table for a course, rather than piece together short boards.
Remove all the old decking from beams, using your hammer and prybar. Pull out all the remaining nails from the beams. Wide deck boards on the ground, face down. Mal the back and the sides of the boards with a thin layer of moisture-sealing primer. Let the primer dry for a day. Measure the length of the porch flooring, perpendicular to the direction of the beams. Cut the board length of your miter saw.
Put the first board in place next to an edge of the porch flooring, with the grooved side against the house. Leave a 3/8-inch hole in the wall. Secure Management Board in place by sliding the pair of nails through the surface at each point where it crosses an girders. Measure and cut the other plank. Put it in place next to the first connecting them with their tongue-and-groove edges. Use a piece of scrap metal decking and your hammer to hit the board tightly against the first. Nail it through the side rather than the top, shooting a nail at an angle of all cross with a crossbeam.tongue and groove porch boards, Porch Flooring Tongue and Groove Pressure Treated Wood, weather treated tongue and groove cedar
This post topic: Porch Floring